Week 15 FYP1
On week 15, I research about how smart energy meter work from the input into output. To identify the progress, the flowchart and block diagram has been made to know how the project flow and at same time i just doing a chapter 3 methodology including a Introduction, Flowchart, Block Diagram and Component.
The above block diagram shows all the operation of proposed project shows the circuit that going to be use. The input of the development is single phase, it is because the supply not being using such a large load. Thus, form that, power electrical will convert the Alternative Current (AC) into Direct Current (DC) to the home appliances. In addition to that, the condition of the relay needs to be normally close for current to flow the utilities and relay is in the condition of normally open when Arduino gave the signal to disconnect the supply.While the main function of Arduino is to give signal and interface to communication module, relay and sensor
The above block diagram shows all the operation of proposed project shows the circuit that going to be use. The input of the development is single phase, it is because the supply not being using such a large load. Thus, form that, power electrical will convert the Alternative Current (AC) into Direct Current (DC) to the home appliances. In addition to that, the condition of the relay needs to be normally close for current to flow the utilities and relay is in the condition of normally open when Arduino gave the signal to disconnect the supply.While the main function of Arduino is to give signal and interface to communication module, relay and sensor
Comments
Post a Comment